Joint tutorials
Stair
Steps between two levels, generated from a footprint.
Step 1
Draw where the stair goes
Press Rectangle (or type rect) and draw it flat on the floor. Then grab one edge and lift it to the upper level — drawing it on a slope in one go is fiddly.
0:00 / 0:07
Step 2
Add the stair generator
With it selected, open Details in the right panel → + Add Generator → Stair Generator. Step count, width and railing are editable there.
Don't see it in the panel? You're probably still holding a face or an edge from the last step. Press Esc once — that drops the part but keeps the rect selected.
Don't see it in the panel? You're probably still holding a face or an edge from the last step. Press Esc once — that drops the part but keeps the rect selected.
0:00 / 0:09